Regular maintenance helps the pool robot retain suction, grip, and movement. A dirty filter or worn brushes can lead to poorer results even when the motor is working as it should.
Short answer: Empty and rinse the filter, check the brushes and wheels, straighten the cable or charge the battery correctly, and store the robot in a protected place.
After each cleaning cycle
Lift the robot by the handle as instructed, not by pulling on the cable. Let the water drain out before lifting it fully. Open the filter basket and rinse away dirt with clean water.
Check that no hair, string, or leaves are caught around the wheels and brushes.
Weekly check during the season
- Inspect brushes and drive tracks
- Clean filter surfaces thoroughly
- Check cable and connector
- Wipe down sensors and water intakes
- Look for cracks or loose parts
Cable and battery
For cable models, the cable should be straightened out and stored without sharp bends. The transformer should be kept dry and placed according to the safety instructions. Battery models should be charged with the correct charger and not left discharged longer than the manufacturer recommends.
Stop using it if the cable, battery, or housing is damaged.
Winter storage
Clean and dry the robot thoroughly. Store it in a frost-free place, protected from direct sunlight, and in a way that does not deform the brushes. Follow specific temperature requirements for the battery.
Go through wear parts before the next season so the robot is ready when the pool is opened.
Frequently asked questions
How often should the filter be cleaned?
As needed and normally after each full cycle when the pool collects a lot of debris. A clogged filter reduces the flow.
Why does the robot climb worse?
A dirty filter, worn brushes, incorrect water balance, or a surface the model is not intended for can be the cause.
Find compatible models in Pooltime's range of pool robots.
Find the right pool robot
Compare pool robots based on pool size, surface finish, and cleaning needs.
See our pool robots
